MKS AWD V6-3.7L (2009)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
NOTICE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these
charges.
1. NOTE: When installing a new ABS module, it must be configured using vehicle as-built data. For additional information, refer to Programmable
Module Installation (PMI) in Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and
Inspection/Programming and Relearning
Remove the Hydraulic Control Unit (HCU). For additional information, refer to Hydraulic Control Unit (HCU) See: Hydraulic Control Assembly
- Antilock Brakes/Service and Repair.
2. Remove and discard the 4 screws.
-
To install, tighten the new screws to 3 Nm (27 lb-in).
3. Remove the ABS module.
4. To install, reverse the removal procedure.