MKS AWD V6-3.7L (2009)
3. Remove the air cleaner assembly.
4. Disconnect the master cylinder brake fluid level indicator switch electrical connector.
5. NOTE: The brake tubes must be installed in the same position and orientation as removed.
Disconnect the brake tubes from the master cylinder.
-
To install, tighten to 22 Nm (16 lb-ft).
-
Cap the brake tubes and plug the master cylinder ports.
6. NOTE: Make sure that the master cylinder-to-booster seal is removed with the master cylinder.
Remove and discard the 2 brake master cylinder nuts and remove the brake master cylinder.
-
To install, tighten the new nuts to 20 Nm (177 lb-in).
7. To install, reverse the removal procedure.
-
Bleed the brake system.
