MKS AWD V6-3.7L (2009)
3. Using a new gasket, install the LH valve cover and the 11 stud bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
4. Connect the 3 LH fuel injector electrical connectors.
5. Install the engine cover stud to the valve cover stud bolt.
-
Tighten to 6 Nm (53 lb-in).
6. Attach all of the wiring harness retainers to the LH valve cover stud bolts.
7. Connect and attach the 2 engine control wiring harness electrical connectors.
8. Connect the LH VCT solenoid electrical connector.
9. Install the oil level indicator.
10. Install the LH ignition coils.