MKS AWD V6-3.7L (2009)
35. Remove the A/C tube-to-evaporator bolt and the 2 A/C tubes.
-
Discard the O-ring seals.
36. Using the floor jack, raise the engine slightly.
37. Remove the 22 engine front cover bolts.
38. Install 6 of the engine front cover bolts (finger-tight) into the 6 threaded holes in the engine front cover.
-
Tighten the bolts one turn at a time in a crisscross pattern until the engine front cover-to-cylinder block seal is released.
-
Remove the 6 bolts and the engine front cover.
Installation
1. NOTICE: Only use a 3M Roloc(R) Bristle Disk (2-in white, part number 07528), to clean the engine front cover. Do not use metal
scrapers, wire brushes or any other power abrasive disk to clean the engine front cover. These tools cause scratches and gouges that make
