MKS AWD V6-3.7L (2009)
No
REPAIR circuit CLS30 (VT/WH) for an open. TEST the system for normal operation.
-------------------------------------------------
R5 CHECK THE PARKING LAMP GROUND CIRCUIT FOR AN OPEN
-
Measure the voltage between the inoperative lamp pins, harness side and ground as follows:
-
Is the voltage greater than 10 volts?
Yes
For a front lamp or license plate lamp, INSTALL a new bulb holder. TEST the system for normal operation.
For a rear lamp, REPAIR or INSTALL a new rear lamp jumper harness. TEST the system for normal operation.
No
REPAIR the ground circuit in question for an open. TEST the system for normal operation.
-------------------------------------------------
R6 CHECK FOR CORRECT SJB OPERATION
-
Disconnect all the SJB connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect all the SJB connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new SJB. TEST the system for normal operation.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
-------------------------------------------------
Pinpoint Test S: The Parking, Rear Or License Plate Lamps Are On Continuously
Parking, Rear and License Plate Lamps
Pinpoint Tests
