MKS AWD V6-3.7L (2009)
7. Within 2 minutes of the horn sounding, place the Tire Pressure Monitor Activation Tool on the RF tire sidewall opposite (180 degrees) from the
valve stem and press and release the test button to train the RF tire pressure sensor.
8. NOTE: Do not wait more than 2 minutes between training each sensor or the will time out and the entire procedure must be repeated.
Repeat Step 7 for the RR and LR tires.
The procedure is completed affer the last tire has been trained. When the training procedure is complete, the message center (if equipped) will display
TIRE TRAINING COMPLETE.
For vehicles not equipped with a message center, successful completion of the training procedure will be verified by turning the ignition switch to the
OFF position without the horn sounding. If the horn sounds twice when the switch is turned to the OFF position, the training procedure was not
successful.
9. Using the scan tool, locate the updated sensor identifiers trained to the and document them on the applicable warranty claim.
10. NOTE: This step is required to clear DTC C2780, cause the to exit the manufacturing mode and to make sure there are no other concerns with a
newly programmed
If the sensors are being trained due to the installation of a new , clear any DTCs and carry out the On-Demand Self Test.
TPMS Sensor Training - Intelligent Access (IA)
Tire Pressure Monitoring System (TPMS) Sensor Training - Intelligent Access (IA)
