MKS AWD V6-3.7L (2009)
-
Is the resistance less than 5 ohms?
Yes
GO to H3.
No
REPAIR the circuit. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
H3 CHECK THE HS-CAN CIRCUITS BETWEEN THE 4X4 CONTROL MODULE AND THE DLC FOR AN OPEN
-
Measure the resistance between the 4X4 control module C281-3, circuit VDB04 (WH/BU), harness side and the DLC C251-6, circuit VDB04
(WH/BU), harness side.
-
Measure the resistance between the 4X4 control module C281-11, circuit VDB05 (WH), harness side and the DLC C251-14, circuit VDB05
(WH), harness side.
-
Are the resistances less than 5 ohms?
Yes
GO to H4.
No
REPAIR the circuit in question. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
H4 CHECK FOR CORRECT 4X4 CONTROL MODULE OPERATION
-
Disconnect the 4X4 control module connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the 4X4 control module connector and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?