MKS AWD V6-3.7L (2009)
Door Module: Service and Repair
Driver Door Module (DDM)
Removal and Installation
1. NOTE: This step is necessary only if the Driver Door Module (DDM) is being replaced.
NOTE: Prior to the replacement of the module, it is necessary to upload the module configuration information to the scan tool. This information
must be downloaded into the new module after installation.
Upload the module configuration information from the DDM.
2. Remove the LH door trim panel.
3. Position the watershield aside and disconnect the 2 DDM electrical connectors.
4. Remove the 2 screws and the DDM.
5. To install, reverse the removal procedure.
