MKS AWD V6-3.7L (2009)
1. For additional information, refer to the procedures.
Heated Seat Module - Rear
Heated Seat Module - Rear
Removal and Installation
1. Remove the rear seat backrest. For additional information, refer to Seat Backrest - Rear See: Body and Frame/Seats/Seat Back/Service and
Repair/Removal and Replacement/Rear Seats/Seat Backrest - Rear.
2. Release part of the close-out trim cover at the bottom LH side and position aside.
3. Release the bottom LH cushion trim cover J-clip.
4. Disconnect the 2 electrical connectors, remove the scrivet and heated seat module.
5. To install, reverse the removal procedure.
6. Carry out the auto-configuration sequence to program the heated seat module for use with a dual momentary switch.
-
Start the vehicle and push the low button on either heated seat switch.
-
Operate the heated seats, monitor the indicators and verify the system is operating correctly in high and low.
