MKS AWD V6-3.7L (2009)
Cruise Control Module: Service and Repair
Cruise-Control Module (C-CM)
Removal and Installation
NOTE: The speed control sensor is also known as the forward looking sensor.
NOTE: If a new C-CM is installed, the C-CM requires a parameter reset to allow the C-CM and the speed control sensor to recognize each other. Failure
to carry out the parameter reset to the C-CM may result in an inoperative adaptive cruise control system condition.
1. Remove the rear seat.
2. Remove the C-CM push-pin with a suitable pry-tool.
-
Disconnect the electrical connector.
3. Remove the 2 C-CM nuts and the C-CM.
-
To install, tighten to 11 Nm (97 lb-in).
4. If replacing the bracket, remove the 2 C-CM bracket nuts and the bracket.
-
To install, tighten to 11 Nm (97 lb-in).
5. To install, reverse the removal procedure.
-
Follow the scan tool on-screen instructions to carry-out the C-CM calibration procedure.
-
Follow the operating instructions shown on the Integrated Diagnostic System (IDS).
-
After completion of the test, verify that the test completed successfully.
-
Follow the prompts to drive the vehicle after successful completion of the test.
