MKS AWD V6-3.7L (2009)
9. Fold the backrest trim cover back around the backrest foam pad and backrest frame.
-
Make sure both deployment chute front edges do not fold over.
10. Pull the backrest foam pad and backrest cover around the backrest frame.
11. Fasten the backrest trim cover.
-
Attach only the lower and side backrest trim cover J-clips to the backrest frame.
-
Do not attach the backrest trim cover upper J-clips to the backrest frame wires at this time.
12. Attach and connect the backrest TED.
-
Engage the backrest TED to the backrest foam pad wire.
-
Connect the backrest TED electrical connector and install the pin-type retainer to the backrest frame.
13. Attach the remaining backrest trim cover J-clips to the backrest frame and wires.
14. Wrap the backrest trim cover around the recliner and attach the hook-and-loop strips and J-clip to the recliner.
-
Make sure both recliner bolt holes are accessible.
-
Repeat for the other side.
15. Attach the backrest trim cover hook-and-loop strips near the bottom and at the sides.
16. Attach the 2 carpet flap toe-kick J-clips to the backrest wires.
17. Install the backrest panel in the following sequence.
NOTICE: The clips in the middle of the backrest panel can be damaged if the bottom of the backrest panel is not pivoted away from the
seat.
1. Pivot the bottom of the backrest panel out as far as it will go and slide the backrest panel up, engaging the upper retainers behind the backrest
