MKS AWD V6-3.7L (2009)
3. Depress the 2 tabs and remove the selector lever cable from the selector lever.
4. Disconnect the electrical connector.
5. NOTE: Use a paint pen to mark the front and rear position of the selector lever with respect to the console.
Remove the 4 selector lever bolts and the selector lever from the vehicle.
Installation
NOTE: If re-using the selector lever, align the paint marks made on the selector lever and console made during removal.
NOTE: If the selector lever was not marked prior to removal, use Ford service part, selector lever service insert, to align the selector lever.
1. Install the selector lever service inset into the rear center hole in the selector lever on the bottom side of the selector lever. This will make sure of
proper alignment of the selector lever to the console.
2. Install the selector lever and the 4 selector lever bolts.
-
Tighten to 10 Nm (89 lb-in).
3. Connect the electrical connector.
