MKS AWD V6-3.7L (2009)
2. NOTICE: Make sure not to pinch the Turbine Shaft Speed (TSS), Output Shaft Speed (OSS) or Transmission Range (TR) sensor wiring
harnesses when installing the solenoid body. Damage to the wiring harness will occur.
NOTE: Install the different length bolts in the locations noted during disassembly.
Install the solenoid body and the 11 bolts.
1. 42 mm (1.65 in) bolt
2. 63 mm (2.48 in) bolts
3. 80 mm (3.14 in) bolts
4. 95 mm (3.74 in) bolts
3. Tighten the solenoid body bolts in the sequence shown.
-
Tighten to 12 Nm (106 lb-in).
4. Route the OSS sensor wiring harness and connect the electrical connector.
