MKS FWD V6-3.7L (2011)
11. NOTE:
-
The hex-holding feature can be used to prevent turning of the stud while installing the nuts.
-
RH shown, LH similar.
Install new tie-rod end nuts.
-
Tighten to 150 Nm (111 lb-ft).
12. NOTE: RH shown, LH similar.
Install new upper stabilizer bar link nuts.
-
Tighten to 150 Nm (111 lb-ft).
Vehicles equipped with HPAS
13. Remove the power steering gear support from the underbody of the vehicle.
14. Install the power steering gear-to-front subframe bolts and nuts.
-
Tighten to 117 Nm (86 lb-ft).
15. Install the power steering line bolts.
-
Tighten to 7 Nm (62 lb-in).
16. Install the new stabilizer bar bracket-to-front subframe bolts.
-
Tighten to 50 Nm (37 lb-ft).
17. Install the engine exhaust Y-pipe.
Vehicles equipped with EPAS
18. Install the RH and LH exhaust flexible pipes.
All vehicles
