MKS FWD V6-3.7L (2011)
Subframe - Rear
Removal and Installation
1. Measure and record the vehicle ride height.
2. Remove the rear wheels.
3. With a wax pencil, mark the relational alignment of the rear subframe to the underbody at the mounting locations.
4. NOTE: Index-mark the driveshaft before disconnecting from the rear drive axle.
Remove and discard the 6 driveshaft bolts and position the driveshaft aside.
-
To install, tighten the new bolts to 25 Nm (18 lb-ft).
5. Remove and discard the sway bar link upper nuts and reposition the sway bar.
