MKS FWD V6-3.7L (2011)
12. Remove the park brake cable from the caliper.
13. Remove the rear brake caliper bolts.
-
To install, tighten to 103 Nm (76 lb-ft).
14. NOTE: It is not necessary to disconnect the hydraulic brake lines.
Remove the rear calipers and position aside. Attach to the body using mechanic's wire.
15. Remove the 4 rear subframe bracket bolts. Discard the bolts.
-
To install, tighten the new bolts to 55 Nm (41 lb-ft).
16. NOTICE: When positioning the lifting table, be sure to support the rear subframe on the subframe rails. Do not lift on the rear
differential or rear control arms, damage may occur.
Position the Powertrain Lift Table under the subframe.
17. Remove and discard the 2 front bolts of the rear subframe.
-
To install, tighten the new bolts to 200 Nm (148 lb-ft).
18. Remove and discard the 2 rear bolts of the rear subframe.
-
To install, tighten the new bolts to 200 Nm (148 lb-ft).