MKS FWD V6-3.7L (2011)
6. NOTE: Before tightening the lower shock bolts, use a jackstand to raise the rear suspension until the distance between the center of the hub and
the lip of the fender is equal to the measurement taken in the Removal procedure (curb height).
Remove the rear shock lower bolts.
-
To install, tighten to 175 Nm (125 lb-ft).
7. Disconnect the main subframe electrical connector.
8. Remove the intermediate parking brake cable bracket bolt from the frame.
-
To install, tighten to 12 Nm (106 lb-in).
9. Disconnect the intermediate parking brake cable from the front park brake cable.
10. Remove the rear park brake cable bracket and reposition.
11. Remove the wheel opening park brake cable bracket bolt and reposition the bracket.