MKS FWD V6-3.7L (2011)
to act as the receiver cup.
-
Make sure the arrow on the Rear Drive Unit (RDU) Bushing (70 mm) Remover/Installer 204-616/2 is pointed toward the rear subframe when
removing the bushing.
Assemble the Rear Drive Unit (RDU) Bushing (65 mm) Remover/Installer 204-618 and Rear Drive Unit (RDU) Bushing (70 mm)
Remover/Installer 204-616 to the rear subframe and press out the bushing.
Installation
NOTE: There are 2 RDU front bushings in the subframe. This procedure shows how to install one bushing. The procedure for the remaining RDU
bushing is identical.
1. NOTE: Make sure the alignment marks on the Rear Drive Unit (RDU) Bushing (70 mm) Remover/Installer 204-616/2 are aligned with the
anti-rotation tabs on the RDU bushing.
Install the RDU bushing into the Rear Drive Unit (RDU) Bushing (70 mm) Remover/Installer 204-616/2.
2. NOTE: Make sure the alignment marks are properly aligned on both Rear Drive Unit (RDU) Bushing (70 mm) Remover/Installer 204-616/1 and
Rear Drive Unit (RDU) Bushing (70 mm) Remover/Installer 204-616/2 and the anti-rotation tabs are properly seated in the Rear Drive Unit
(RDU) Bushing (70 mm) Remover/Installer 204-616.
Install the Rear Drive Unit (RDU) Bushing (70 mm) Remover/Installer 204-616/2 onto the RDU bushing.
3. NOTE:
-
Make sure the arrow on the Rear Drive Unit (RDU) Bushing (70 mm) Remover/Installer 204-616/2 is visible on the bottom and facing away
from the subframe. The arrow must remain straight so that the bushings are correctly indexed into the subframe.
-
When installing the RDU bushing, Rear Drive Unit (RDU) Bushing (65 mm) Remover/Installer 204-618/2 will fall away as the RDU bushing
is installed into the subframe. The Rear Drive Unit (RDU) Bushing (70 mm) Remover/Installer does not control the depth of the bushing. The
RDU bushing is fully seated when the Rear Drive Unit (RDU) Bushing (70 mm) Remover/Installer falls away from the subframe, do not
