MKT AWD V6-3.5L Turbo (2010)
19. Remove the pivot grommet.
20. Remove the screw and stationary foot cover.
21. Remove the pin-type retainer, screw and RH recliner cover.
22. NOTE: Note all cable routing for correct installation.
Remove the cushion frame yoke-to-RH recliner bolt, route out the cable and remove the RH recliner.
-
To install, tighten to 42 Nm (31 lb-ft).
23. Remove the hog rings and cushion cover.
24. NOTICE: When installing the backrest frame, make sure to follow the torque sequence or damage to the components may occur.
To assemble, reverse the disassembly procedure.
