MKT AWD V6-3.5L Turbo (2010)
Exterior Lighting Module: Service and Repair
Ballast
Removal and Installation
NOTE: If the ballast is glued to the headlamp assembly, it is not removable. If the ballast needs to be replaced, the headlamp assembly must be
replaced.
1. Remove the headlamp assembly. For additional information, refer to Headlamp Assembly See: Lighting and Horns/Headlamp/Service and Repair.
2. Remove the 4 screws and the ballast.
-
Disconnect the electrical connectors.
3. To install, reverse the removal procedure.