MKT AWD V6-3.5L Turbo (2010)
Installation
1. Clean the transaxle support insulator bolts using a wire brush and apply new threadlock to the threads.
2. Install the 2 upper transaxle support insulator bolts.
-
Tighten to 55 Nm (41 lb-ft).
3. Install the 2 lower transaxle support insulator bolts.
-
Tighten to 55 Nm (41 lb-ft).
4. Install the transaxle support insulator bracket and install the bolt and the 3 nuts.
-
Tighten the bolt to 80 Nm (59 lb-ft).
-
Tighten the nuts to 63 Nm (46 lb-ft).
5. Remove the Engine Support Bar.
