MKT FWD V6-3.7L (2010)
programmable parameters, refer to Information Bus.
NOTE: When programming the auto-unlock feature using the door lock control switch method, the following steps must be carried out within 30
seconds or the procedure needs to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.
1. NOTE: Prior to beginning, make sure the ignition is in the OFF mode and all vehicle doors are closed.
Switch the ignition from the OFF to the RUN mode.
2. Press the unlock button on the door lock control switch 3 times.
3. Switch the ignition from the RUN to the OFF mode.
4. Press the unlock button on the door lock control switch 3 times.
5. Switch the ignition back to the RUN mode. The horn chirps once to indicate that programming mode is entered.
6. To enable/disable the autolock feature, press the lock button on the door lock control switch, then the unlock button. The horn chirps once if the
auto-unlocks are disabled or twice (one short chirp followed by a honk) if the auto-unlocks are enabled.
7. Switch the ignition to the OFF mode. The horn chirps once to signal that the programming is complete.
Programming the Auto-Unlock Feature Using the Keyless Entry Keypad
NOTE: The auto-unlock feature can be activated or deactivated independently of the autolock feature.
NOTE: The auto-unlock feature is also a programmable parameter and can be enabled/disabled with a scan tool. For additional information on
programmable parameters, refer to Information Bus.
1. Switch the ignition to the OFF mode and close all vehicle doors.
2. Enter the permanent factory set 5-digit keyless entry keypad code.
3. Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press and release the 7/8 button. While still holding the 3/4 button,
press and release the 7/8 button a second time.
4. Release the 3/4 button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.
Programming the Auto-Unlock Feature Using the Instrument Panel Cluster (IPC) Message Center
NOTE: The auto-unlock feature can be activated or deactivated independently of the autolock feature.
NOTE: The auto-unlock feature is also a programmable parameter and can be enabled/disabled with a scan tool. For additional information on
programmable parameters, refer to Information Bus.
1. Press the SETUP button on the message center switch until AUTOUNLOCK [ON] OFF is displayed.
2. Press the RESET button to select ON or OFF. If auto-unlock is enabled, the message center has brackets around the [ON] display. If auto-unlock
is disabled, the message center has brackets around the [OFF] display.
