MKT FWD V6-3.7L (2010)
Parking Assist Distance Sensor: Service and Repair
Active Park Assist Sensor
Active Park Assist Sensor
NOTE: LH side shown, RH side similar.
Removal and Installation
1. Remove the front lower air deflector. For additional information, refer to Bumper - Exploded View, Front in Bumper.
2. Disconnect the electrical connector.
3. With a suitable tool (such as a flat-blade screwdriver), gently pry the retaining tabs to remove the active park assist sensor(s).
-
Remove the active park assist sensor(s) from the front bumper cover.
4. To install, reverse the removal procedure.
5. After installing the sensor(s), use the scan tool to verify that the active park assist sensor PIDs responding correctly. Carry out the Azimuth System
Check See: Collision Avoidance and Parking Assist Systems/Testing and Inspection/Component Tests and General Diagnostics/Active Park
Assist. If the active park assist sensor does not respond correctly, refer to Active Park Assist See: Collision Avoidance and Parking Assist
Systems/Testing and Inspection in the Diagnosis and Testing.
