MKT FWD V6-3.7L (2010)
Trim Panel: Service and Repair
A-Pillar Trim Panel
A-Pillar Trim Panel
Removal and Installation
NOTICE: The A-pillar speaker grille is not serviceable. Do not attempt to remove the speaker grille. Failure to follow this instruction will
result in damage to the A-pillar trim panel.
1. Remove the instrument panel side finish panel.
-
Pull outward to release the retaining clips.
2. Remove the lower A-pillar trim panel.
-
Pull outward to release the retaining clips.
3. Pull outward on the A-pillar trim panel to release the clips.
4. Twist the side air curtain tether 180 degrees so that the tether will release from the A-pillar trim panel.
5. If equipped, disconnect the speaker electrical connector.
6. Pull the A-pillar trim panel towards the rear of the vehicle to remove.
7. WARNING: A new A-pillar trim panel tether must be installed if the tether is damaged or does not fasten correctly. During a side air
curtain deployment the A-pillar trim panel tether helps prevent the trim from striking the occupant. Failure to follow this instruction
may result in serious injury to vehicle occupant(s).
NOTICE: Alignment tabs must be positioned properly for installation. Failure to properly align tabs may result in damage to the
component.
To install, reverse the removal procedure.
