MKT FWD V6-3.7L (2010)
the same position.
Remove the 8 front track-to-housing screws.
10. NOTE: Protect the vehicle interior from grease.
Drop the front of the guide track down while sliding the entire track and mechanism assembly forward and down.
-
Carefully pull the front shade guide foot out of the rear of the front guide track to release the shade cable.
-
Continue sliding the track forward and down. The drive cable will slowly withdraw from the drive tube until the entire assembly is free.
Installation
1. NOTE: Protect the vehicle interior from grease.
NOTE: If installing a new roof opening panel guide track and mechanism, remove and discard the shade cable from the new assembly and reuse
the existing shade cable.
While holding the track and mechanism assembly, slowly insert the sliding glass drive cable into the drive tube. Insert the shade cable into the
track and make sure the front drive tube bracket is fully seated into the track assembly.
2. Install the 8 front track-to-housing screws.
-
Align the track to the marks previously made. Tighten to 5 Nm (44 lb-in).
3. Install the front drive tube bracket-to-guide-track screw. Tighten to 5 Nm (44 lb-in).
4. NOTE: LH shown, RH similar.
Install the air deflector catcher bracket outer screw on the affected track.
-
Tighten to 2 Nm (18 lb-in).
