MKT FWD V6-3.7L (2010)
2. NOTICE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the
backrest foam pad.
Separate the hook-and-loop strips and invert the backrest cover up as far as it will go.
3. Disconnect the backrest Thermo-Electric Device (TED), power lumbar motor and disengage the wire harness pin-type retainers.
-
Route the wire harness out of the backrest frame.
4. Remove the 4 recliner-to-backrest frame bolts.
-
To install, tighten to 50 Nm (37 lb-ft).
5. To install, reverse the removal procedure.
Seat Recliner - Second Row, Bucket
Seat Recliner - Second Row, Bucket
Removal and Installation
WARNING: Keep hands clear of all moving seat mechanisms when releasing the recliner lever. The recliners are spring loaded and release
with high force. Failure to follow these instructions may result in serious personal injury.
NOTE: For parts identification and location, refer to Seat - Exploded View, Second Row See: Service and Repair/Rear Seat/Seat - Exploded View,
Second Row.
