MKT FWD V6-3.7L (2010)
4. Remove the backrest foam pad from the backrest frame.
-
Discard the backrest foam pad with heater mat.
Installation
1. Install a new backrest heater mat onto a new backrest foam pad.
1. Route the backrest heater mat wire harness and electrical connector through the backrest foam pad to the other side.
2. Position the backrest heater mat onto the backrest foam pad so the opening aligns to the wire in the backrest foam pad.
-
Tuck the backrest heater mat into the backrest foam pad trench.
3. Make sure the backrest heater mat stays in place, remove the paper strips from under the backrest heater mat and adhere to the backrest foam
pad, laying it flat with no wrinkles.
4. Position the wire harness in the foam pad notch.
2. Install the backrest foam pad onto the backrest frame.
3. Connect the backrest heater mat electrical connector.
4. Tuck the heater mat wire harness between the inboard pivot cover and pivot.
5. Install the outer pivot cover.
6. Install the backrest cover. For additional information, refer to Seat Backrest Cover - Second Row, 40 Percent, Bench See: Seat Cover/Service and
Repair/Rear Seat/Seat Backrest Cover - Second Row, 40 Percent, Bench.
Seat Cushion Heater Mat - Second Row, 60 Percent
Seat Cushion Heater Mat - Second Row, 60 Percent
Removal
NOTICE: The heater mat is not designed to be separated from the foam pad. Doing so will damage the foam pad. Install a new foam pad and
heater mat. Failure to follow this instruction can result in seat component damage and system failure.
NOTE: For parts identification and location, refer to Seat - Exploded View, Second Row See: Service and Repair/Rear Seat/Seat - Exploded View,
Second Row.
1. Remove the cushion trim cover. For additional information, refer to Seat Cushion Cover - Second Row, 60 Percent See: Seat Cover/Service and
Repair/Rear Seat/Seat Cushion Cover - Second Row, 60 Percent.
2. Lift the cushion foam pad away from the cushion frame and disconnect the cushion heater mat. Discard the cushion foam pad and heater mat.
