MKT FWD V6-3.7L (2010)
11. To install a new LH power seat latch, from the LH load floor flapper panel, detach the 3 wire harness retainers, disconnect the electrical connector,
disengage and remove the Power-Fold Seat Module (PFSM) with wire harness.
12. On the side of the power seat latch to be installed new, remove the 2 load floor panel screws at the back of the cushion.
13. Pull out to release the retainers and remove the load floor panel.
14. Remove the screw, release the tab and remove the latch cover.
15. Release the cushion cover retainers from the cushion frame enough to access the power seat latch retainers and electrical connectors.
16. Remove the power seat latch in the following sequence.
1. Remove the 2 screws.
-
To install, tighten to 30 Nm (22 lb-ft).
2. Disconnect the 2 electrical connectors.
17. To install, reverse the removal procedure.
