MKT FWD V6-3.7L (2010)
11. Remove the lockpin from the LH secondary timing chain tensioner.
RH camshafts
12. NOTE: Use a camshaft sprocket bolt to turn the camshafts.
Rotate the RH camshafts to the TDC position and install the Camshaft Holding Tool on the flats of the camshafts.
13. Assemble the RH VCT assembly, the RH exhaust camshaft sprocket and the RH secondary timing chain.
-
Align the colored links with the timing marks.
14. Position the RH secondary timing assembly onto the camshafts.
15. Install the new VCT bolt and new exhaust camshaft bolt and the original washer. Tighten in 4 stages.
-
Stage 1: Tighten to 40 Nm (30 lb-ft).
-
Stage 2: Loosen one full turn.
-
Stage 3: Tighten to 10 Nm (89 lb-in).
-
Stage 4: Tighten 90 degrees.
