MKT FWD V6-3.7L (2010)
-
Tighten to 10 Nm (89 lb-in).
-
Remove the lockpin.
23. As a post-check, verify correct alignment of all timing marks.
24. Inspect the VCT housing seals for damage and replace as necessary.
25. NOTICE: Make sure the dowels on the Variable Camshaft Timing (VCT) housing are fully engaged in the cylinder head prior to
tightening the bolts. Failure to follow this process will result in severe engine damage.
Install the LH VCT housing and the 3 bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
26. NOTICE: Make sure the dowels on the Variable Camshaft Timing (VCT) housing are fully engaged in the cylinder head prior to
tightening the bolts. Failure to follow this process will result in severe engine damage.
Install the RH VCT housing and the 3 bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
