MKT FWD V6-3.7L (2010)
33. NOTICE: The thread sealer on the engine mount studs (including new engine mount studs if applicable) must be cleaned off with a wire
brush and new Threadlock and Sealer applied prior to installing the engine mount studs. Failure to follow this procedure may result in
damage to the engine mount studs or engine.
Install the engine mount studs in the following sequence.
1. Clean the front cover engine mount stud holes with pressurized air to remove any foreign material.
2. Clean all the thread sealer from the engine mount studs (old and new studs).
3. Apply new Threadlock and Sealer to the engine mount stud threads.
4. Install the 2 engine mount studs.
-
Tighten to 20 Nm (177 lb-in).
34. Install the engine mount bracket and the 2 bolts.
-
Tighten to 24 Nm (18 lb-ft).
35. NOTE: Apply clean engine oil to the crankshaft front seal bore in the engine front cover.
Using the Crankshaft Vibration Damper Installer and Front Crankshaft Seal Installer, install a new crankshaft front seal.
36. NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.
