MKT FWD V6-3.7L (2010)
114. Connect the upper radiator hose, lower radiator hose and heater hose to the thermostat housing.
115. Install the engine wiring harness retainer to the bulkhead.
1. Slide the wiring harness in the bulkhead.
2. Make sure the wiring harness retainer tab is below the bulkhead lip.
116. Connect the 2 PCM electrical connectors.
117. Connect the PCM and engine harness electrical connectors.
-
Attach the wiring harness retainer.
118. Install the Evaporative Emission (EVAP) canister purge valve. For additional information, refer to Evaporative Emissions System.
119. Attach the EVAP tube pin-type retainer to the upper intake manifold.
