MKT FWD V6-3.7L (2010)
NOTICE: Do not use wire brushes, power abrasive discs or 3M(TM) Roloc(R) Bristle Disk (2-in white, part number 07528) to clean the
sealing surfaces. These tools cause scratches and gouges that make leak paths. They also cause contamination that will cause premature
engine failure. Remove all traces of the gasket.
Clean the sealing surfaces of the cylinder block in the following sequence.
1. Remove any large deposits of silicone or gasket material.
2. Apply silicone gasket remover and allow to set for several minutes.
3. Remove the silicone gasket remover. A second application of silicone gasket remover may be required if residual traces of silicone or gasket
material remain.
4. Apply metal surface prep to remove any remaining traces of oil or coolant and to prepare the surfaces to bond. Do not attempt to make the
metal shiny. Some staining of the metal surfaces is normal.
