MKT FWD V6-3.7L (2010)
Air Door Actuator / Motor: Service and Repair
Temperature Blend Door Actuator - RH
Temperature Blend Door Actuator - RH
Removal and Installation
1. Remove the instrument panel upper section. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
2. Disconnect the temperature blend door actuator jumper harness electrical connector.
3. Remove the 2 RH temperature blend door actuator screws.
4. Reposition the RH temperature blend door actuator to allow access to the electrical connector and disconnect the RH temperature blend door
actuator electrical connector.
5. Remove the RH temperature blend door actuator.
6. To install, reverse the removal procedure.
