MKT FWD V6-3.7L (2010)
Air Bag(s) Arming and Disarming: Service and Repair
Supplemental Restraint System (SRS) Deactivation and Reactivation
Supplemental Restraint System (SRS) Deactivation and Reactivation
Deactivation
WARNING: Always carry or place a live air bag module with the air bag and deployment door/trim cover/tear seam pointed away from the
body. Do not set a live air bag module down with the deployment door/trim cover/tear seam face down. Failure to follow these instructions may
result in serious personal injury in the event of an accidental deployment.
WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction
may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
WARNING: Never disassemble or tamper with safety belt buckle/retractor pretensioners or adaptive load limiting retractors or probe the
electrical connectors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load
limiting retractors which increases the risk of serious personal injury or death.
WARNING: Do not handle, move or change the original horizontal mounting position of the restraints control module (RCM) while the RCM
is connected and the ignition switch is ON. Failure to follow this instruction may result in the accidental deployment of the Safety Canopy(R)
and cause serious personal injury or death.
WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in
serious personal injury or death.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Supplemental
Restraint System (SRS) Depowering and Repowering.
2. Remove the driver air bag module. For additional information, refer to Driver Air Bag Module See: Restraint Systems/Air Bag Systems/Air
Bag/Service and Repair/Driver Air Bag Module.
3. If equipped, remove the Rear Entertainment Module (RETM). For additional information, refer to Accessories and Optional Equipment.
4. Disconnect the passenger air bag module electrical connector.
5. NOTE: Passenger seat shown, driver similar.
Under the passenger seat, slide and disengage the side air bag module electrical connector locking clip, release the tab and disconnect the electrical
connector.