lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3329 > < Initial Inspection and Diagnostic Overview|Page 3327
Page 103
background image

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AF50. 

No

GO to AF35.

-------------------------------------------------
AF35 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE IPC DISCONNECTED

 

-

Disconnect: IPC C220 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AF51. 

No

If the vehicle is equipped with an Accessory Protocol Interface Module (APIM), GO to AF36. 

If the vehicle is not equipped with an APIM, GO to AF37.

-------------------------------------------------
AF36 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE APIM DISCONNECTED

 

-

Disconnect: APIM C3342 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AF52. 

No

Initial Inspection and Diagnostic Overview|Page 3329 > < Initial Inspection and Diagnostic Overview|Page 3327