MKT FWD V6-3.7L (2010)
-------------------------------------------------
AG1 CHECK THE DLC PINS FOR DAMAGE
-
Ignition OFF.
-
Disconnect the scan tool cable from the Data Link Connector (DLC).
-
Inspect DLC pins 3 and 11 for damage.
-
Are DLC pins 3 and 11 OK?
Yes
GO to AG2.
No
REPAIR the DLC as necessary. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
AG2 CHECK THE MS-CAN TERMINATION RESISTANCE
-
Disconnect: Negative Battery Cable .
-
Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.
-
Is the resistance between 54 and 66 ohms?
Yes
GO to AG3.
No
An intermittent fault is not present. GO to Pinpoint Test AH. See: Pinpoint Test AH: No Medium Speed Controller Area Network (MS-CAN)
Communication, All Modules Are Not Responding
-------------------------------------------------
AG3 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND
-
Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.
