lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3353 > < Initial Inspection and Diagnostic Overview|Page 3351
Page 127
background image

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with an audio Digital Signal Processing (DSP) module, GO to AH14. 

If the vehicle is not equipped with an audio DSP module, GO to AH15. 

No

CONNECT the negative battery cable. GO to AH67.

-------------------------------------------------
AH14 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE AUDIO DSP MODULE
DISCONNECTED

 

-

Disconnect: Audio DSP Module C4326a .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to AH15. 

No

CONNECT the negative battery cable. GO to AH68.

-------------------------------------------------
AH15 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE FCIM DISCONNECTED

 

-

Disconnect: Front Controls Interface Module (FCIM) C2403 .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with a Liftgate/Trunk Module (LTM), GO to AH16. 

If the vehicle is not equipped with an LTM, GO to AH17. 

Initial Inspection and Diagnostic Overview|Page 3353 > < Initial Inspection and Diagnostic Overview|Page 3351