lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3364 > < Initial Inspection and Diagnostic Overview|Page 3362
Page 138
background image

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AH69. 

No

If the vehicle is equipped with a Liftgate/Trunk Module (LTM), GO to AH43. 

If the vehicle is not equipped with an LTM, GO to AH43.

-------------------------------------------------
AH43 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE LTM DISCONNECTED

 

-

Disconnect: LTM C4174b .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AH70. 

No

GO to AH44.

-------------------------------------------------
AH44 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE HVAC MODULE
DISCONNECTED

 

-

Disconnect: HVAC Module C2356a .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AH71. 

No

Initial Inspection and Diagnostic Overview|Page 3364 > < Initial Inspection and Diagnostic Overview|Page 3362