MKT FWD V6-3.7L (2010)
Knock Sensor: Service and Repair
Knock Sensor (KS) - 3.7L
NOTE: LH cylinder head removed from art for clarity.
Removal and Installation
1. Remove the thermostat housing. For additional information, refer to Cooling System &/or Engine Block Heater.
2. Remove the lower intake manifold. For additional information, refer to Engine.
3. Remove the coolant tube.
-
Discard the O-ring seal.
4. Disconnect the Knock Sensor (KS) electrical connector.
5. Remove the 2 bolts and the KS.
-
To install, tighten to 20 Nm (177 lb-in).
6. To install, reverse the removal procedure.
-
Lubricate the new O-ring seal with clean engine coolant.
