MKT FWD V6-3.7L (2010)
3. Clean the power steering pump and supply tube area thoroughly with Motorcraft(R) Metal Brake Parts Cleaner and allow the surface to dry. Surface
must be clean and dry in order for the sealant to bond. (Figure 2)
4. Apply a generous bead of Motorcraft(R) Ultra Silicone Sealant around the supply tube-to-pump housing connection. Make sure the sealant covers the
surface all the way around the tube to form a good air tight seal. (Figure 2)
5. Allow the sealant to dry according to the instructions on the tube.
6. Install the RH splash shield and the 7 pin-type retainers.
7. Top off the power steering fluid level.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
100601A
2010 Taurus, MKS, Flex
0.4 Hr.
And MKT: Apply Sealant
Around The Supply Tube
To Pump Housing
Connection (Do Not Use
With Any Other Labor
Operations)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
3A674
07