MKT FWD V6-3.7L (2010)
Control Arm Bushing: Service and Repair
Lower Arm Bushing
Removal
1. Remove the lower arm. For additional information, refer to Lower Arm See: Service and Repair/Front Suspension.
2. Index-mark the bushing-to-lower arm position for reference during the installation procedure.
3. NOTE: The Drive Pinion Bearing Cone Remover is used to secure the lower arm bushing while separating the bushing from the lower arm.
Using the Drive Pinion Bearing Cone Remover, a suitable press and adapters, remove the lower arm bushing.
Installation
1. NOTE: The Drive Pinion Bearing Cone Remover is used to clamp and hold the lower arm while installing the bushing.
Install the Drive Pinion Bearing Cone Remover onto the lower arm.
2. Transfer the index mark to the new lower arm bushing.
3. NOTE: The Drive Pinion Bearing Cone Remover is used to clamp and hold the lower arm while installing the bushing.
Align the index marks and using the Drive Pinion Bearing Cone Remover, a suitable press and adapters, install a new lower arm bushing.
4. Install the lower arm. For additional information, refer to Lower Arm See: Service and Repair/Front Suspension.
