MKT FWD V6-3.7L (2010)
-
To install, tighten the new nut to 55 Nm (41 lb-ft).
3. Remove the wheel and tire. For additional information, refer to Wheels and Tires.
4. NOTE: Use the hex-holding feature to prevent the stabilizer bar link stud from turning while removing or installing the nut.
Remove and discard the stabilizer bar link upper nut and disconnect the link from the wheel knuckle.
-
To install, tighten the new nut to 55 Nm (41 (lb-ft).
5. Remove and discard the shock absorber lower bolt and remove the shock absorber.
-
To install, tighten the new bolt to 175 Nm (129 lb-ft).
6. To install, reverse the removal procedure.
