MKT FWD V6-3.7L (2010)
4. Using a suitable awl, poke a small hole in the halfshaft seal.
5. Using a suitable dent puller, remove the halfshaft seal.
Installation
1. Install a new halfshaft seal on the Cover Axle Seal Installer and Handle.
2. Using the Cover Axle Seal Installer and Handle, install the LH halfshaft seal.
3. Install the front LH halfshaft. For additional information, refer to Drive Axles, Bearings and Joints.
4. Check and top off the transmission fluid to the correct level. To check the transmission fluid level, refer to Preliminary Inspection See:
Transmission Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Preliminary Inspection.
