MKT FWD V6-3.7L (2010)
body may occur.
NOTICE: Use care not to break the alignment tabs when removing the solenoid body filter.
Remove the solenoid body filter assembly by pulling it straight up from the alignment tabs. Discard the filter.
8. Remove the 10 bolts, the TR sensor detent spring and the main control valve body.
9. Using a suitable tool, remove and discard the TR sensor locking pin.
10. NOTE: TR sensor removed for clarity.
Make sure that the park pawl actuator rod does not become disengaged from the park pawl and the abutment by keeping the end of the park pawl
actuator rod behind the machined valve body mating surface of the transaxle case. If the park pawl actuator rod becomes disengaged from the park
pawl and the abutment, transaxle removal and disassembly is required to reinstall the actuator rod.
11. NOTICE: Make sure that the park pawl actuator rod does not become disengaged from the park pawl and the abutment, or transaxle
removal and disassembly is required to reinstall the actuator rod.
Remove the TR sensor.
1. Slide the TR sensor down until the manual shaft is out of the transaxle case.
