MKX AWD V6-3.5L (2007)
7. Separate the recliner cable casing and Z-fitting from the LH fold flat recliner.
8. Separate the recliner cable casing and Z-fitting from the RH fold flat recliner.
All seats
9. Disconnect the following electrical connectors, release any retainers and route out the wire harness for following components:
-
Side air bag module (if equipped).
-
Power lumbar motor (if equipped).
-
Power recline motor (if equipped).
-
Thermal electric device (TED) (if equipped).
-
Backrest heater mat (if equipped).
10. Remove the 4 recliner-to-seat track bolts and remove the backrest assembly.
-
If equipped, route out the manual lumbar cable.
Installation
All seats
1. Position the backrest assembly to the seat track and install the 4 recliner-to-seat track bolts.
-
Route the manual lumbar cable (if equipped).
-
Tighten to 50 Nm (37 lb-ft).
2. Route the wire harnesses, connect the electrical connectors and attach the retainers for the following parts. For correct front passenger seat cushion
wire harness routing, refer to Seat Wire Harness Routing-Front Passenger Cushion. See: Locations
-
The side air bag module.
-
The power lumbar motor (if equipped).
-
The power recline motor (if equipped).
-
The thermal electric device (TED) (if equipped).
-
The backrest heater mat (if equipped).
Passenger seat with fold flat backrest
