MKX AWD V6-3.5L (2007)
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Driver seat shown, passenger seat similar.
All seats
1. Position the seat to access all the seat track-to-floor bolts and the safety belt anchor.
2. Depower the supplemental restraint system (SRS).
3. Remove the front seat.
4. Remove the front seat cushion.
5. Release the cushion trim cover retainers from the cushion frame and remove the cushion trim cover and cushion foam pad.
6. CAUTION: Use care when separating the cushion trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn
from the cushion foam pad.
NOTE: A new heater mat will come assembled on a new foam pad.
Remove the cushion trim cover from the cushion foam pad in the following sequence.
1. Separate the hook-and-loop strips.
2. Separate the cushion trim cover wire retainer from the clips in the cushion foam pad.
-
For vehicles with climate controlled seat, on assembly make sure the climate control seat manifold is in place before snapping the cushion
trim cover wire retainer back into the cushion foam pad.
Seats with climate control
7. Remove the cushion climate control seat manifold from the cushion foam pad.
8. Remove the 3 cushion thermal electric device (TED)-to-cushion frame screws.
9. Remove the cushion TED-to-climate control seat cushion adapter screw and remove the TED.
10. Release the clips and remove the cushion TED adapter from the cushion frame.
Heated seats
11. Remove the screw and the heated seat module.
All seats
12. Release the retainers from the cushion frame and remove the cushion support.
All seats
13. To assemble, reverse the disassembly procedure.
14. Install the front seat cushion.
-
For correct front passenger seat cushion wire harness routing, refer to Seat Wire Harness Routing-Front Passenger Cushion. See: Locations
15. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
16. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS.
Seat Cushion - Rear, 40 Percent
SEAT CUSHION - REAR, 40 PERCENT
