MKX AWD V6-3.5L (2007)
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped).
Disconnect the battery ground cable and wait at least one minute.
7. NOTE: Repeat this step for both locking pins.
Using a 3-mm Allen wrench or a suitable tool through the access hole on the backside of the steering wheel, position the tool against the spring
clip and push in, disengaging the clip from the locking pin. With the spring clip disengaged from the locking pin, gently pull back on that side of
the driver air bag module to release it from the steering wheel.
8. CAUTION: Do not pull the driver air bag module electrical connectors out by the locking buttons. Damage to the locking buttons may
occur.
Using a small screwdriver as shown, lift up and release the locking buttons on the driver air bag module electrical connectors. With the locking
buttons released, remove the electrical connectors and the driver air bag module.
9. Open and lower the glove compartment door. Then unhook the glove compartment door from the instrument panel (I/P).
-
If equipped, detach the glove compartment door dampener.
Edge
