MKZ AWD V6-3.5L (2008)
Passenger Seat Cushion (Part 2)
Special Tool(s)
Special Tool(s)
Removal and Installation
WARNING:
-
Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
-
Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in
the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Only the front passenger seat can come equipped with optional fold-flat backrest.
All seats
1. Remove the front seat.
2. Remove the spring clip and manual recliner handle.
3. Remove the cushion side shield in the following sequence.
1
Pull out on the side and rear of the cushion side shield, releasing the retainers.
2
Separate the wire harness pin-type retainers from the cushion side shield.
