MKZ AWD V6-3.5L (2008)
2. Install the 2 rearward backrest-to-floor bolts.
-
Tighten to 47 Nm (35 lb-ft).
3. Position the backrest upright and install the 2 forward backrest-to-floor bolts.
-
Tighten to 47 Nm (35 lb-ft).
4. Check backrest latch and latch release operation.
-
Raise the backrest and check for good backrest fit and latch closure when upright.
Backrest latch alignment
5. If backrest latch alignment is needed, remove the parcel shelf to access the rear backrest latch nuts.
6. Loosen the 2 rear backrest latch nuts and adjust the latch position as necessary for good backrest fit and latch closure when upright.
-
Tighten to 48 Nm (35 lb-ft).
7. Install the parcel shelf.
Backrest
8. Check the rear seat active restraints for operation and accessibility.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
-
Verify the safety belt retractor operates without excessive effort or binding.